44102 Grip 2000 KG FULLY WELDED HYDRAULIC BOTTLE JACK
Bottle style hydraulic jack for the lifting of vehicles or other heavy components and/ or equipment so that maintenance can be performed.
- FEATURES
- Heavy duty steel construction, fully seam welded base and top cap for superior leak resistance
- Fully machined steel (not cast iron) heavy duty base plate
- Quality chrome hydraulic ram and piston pump
- Black baked enamel finish for corrosion resistance
- Australian Standard compliance
- SAFETY
- The jack should be used on hard, level surfaces
- The wheels of the vehicle to be chocked
- Do NOT put a portion of your body under a vehicle supported by a jack
- No person should remain in a vehicle that is being jacked
- Do NOT exceed working load limit
- SPECIFICATIONS
- Working load limit : 2000kg
- Minimum height : 193mm
- Maximum height : 368mm
- Hydraulic lift height: 116mm
- Screw height adjustment : 60mm
- Base plate dimensions : 110(L) x 100(W) x 170(H)mm
- Australian Standard : AS/NZS 2693:2007
- Packaged dimensions : 128(L) x 118(W) x 210(H)mm
- Packaged weight (net) : 4 kg
Please note: Vertical lifts only, if jack is tilted to any angle other than vertical position from base plate the hydraulic system will not operate
- MAINTENANCE NOTE
- It is recommended that the oil level should be approximately 3mm below the oil filler hole.
- To add oil lower the jack to the lowest position, then remove the air vent valve, add oil to the desired level, pump 5 or 6 times to expel any air in the cylinder, and then fasten the air vent valve. DO NOT USE BRAKE FLUID, ALCOHOL, GLYCERINE, DETERGENT, MOTOR OIL OR DIRTY OIL.