CURVE O MARK Pipe Centering Head No.6 from 12mm KC-J1879
Time-saving tool to locate & mark center points on pipe, or points at specific angles. Fitted with adjustable dial bubble protractor.
- Features
- No.6 Model
- For Pipes and Tube from 12mm diameter
- Features 100mm wide Y head
- Aids in the setting of centre lines, establishing angles and marks for butt-ins, location points inside pipes and tanks, laying out key ways, and measuring declivity.
- The standard head model is used on 1/2" diameter pipe and up.
- It features a 4 inch "Y" type head fitted with an adjustable Dial-Set-Level (DSL)
- Tap with a hammer to operate the hardened cantering pin
- .Available in standard or jumbo models.
